TenTec
[Top] [All Lists]

[TenTec] Misc TenTec items FS

To: "TenTec List at contesting (TenTec List at contesting)" <tentec@contesting.com>
Subject: [TenTec] Misc TenTec items FS
From: "Ken Simpson, W8EK" <W8EK@speakeasy.net>
Reply-to: W8EK@speakeasy.net,Discussion of Ten-Tec Equipment <tentec@contesting.com>
Date: Sat, 15 Jul 2006 15:51:39 -0400
List-post: <mailto:tentec@contesting.com>
Misc TenTec items for sale:

TenTec 217 narrow CW 500 hz Crystal Filter
It can be used in the Omni 546 (series B and C), Omni V, VI, 
Argosy, or as roofing filters in the Orion I.  It is for the 9 MHz IF.  
Like new with paper work for $75.

TenTec 218 narrow SSB / wide CW filter
1800 Hz, for the 9 MHz IF.  Will work in the older Omni 
546 (series B and C), the newer Omnis in the 9 MHz IF, 
and in the Argosy, and can also be used as a roofing 
filter in the Orion I.   Like new, with the paper work
for $75.

TenTec 248 noise blanker.
This is the noise blanker that goes in the Omni 546, but not the
newer Omni V or VI.  This one has all the paper work with it,
for $50.

TenTec 252 MO power supply, 20 amp, 13 V DC supply.
Matches the Omni series of transceivers.  It has an
ammeter on front. It works 100% and looks very good.
No scratches or imperfections. With manual for $ 110

TenTec 1150 "Over Voltage Protection"
Made to plug into the 252 series of TenTec power supplies,
and provide protection in case the pass transistor on the
supply would short out.  With paper work for $ 18.

TenTec 299 Voice synthesized frequency read out
This unit is used with the TenTec Omni 546 series A, B, C,
some Argonauts, Corsair, and others.  It will work with 
other rigs (such as the Triton), with minor mods to get 
the right connections.
The 299 is used primarily for blind hams who can not read the
frequency readout on the transceiver.  By pushing a button, it
will "speak" the frequency (to tenth of a KHz).  A front panel
switch permits selection of the entire frequency, or you can
eliminate the MHz, and give only the KHz.  There is also a
volume control on the front panel.
Of course it can also be used to give a "voice digital readout"
to a rig with an analog dial.
This particular unit is in great shape electrically.  Cosmetically
it has some very minor wear.  $ 190 plus shipping from Florida.

Thanks.

73,

Ken, W8EK

Ken Simpson
E-mail to W8EK@speakeasy.net or W8EK@arrl.net
Voice Phone  (352) 732-8400










_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec

<Prev in Thread] Current Thread [Next in Thread>