TenTec
[Top] [All Lists]

Re: [TenTec] Way off topic request

To: "Discussion of Ten-Tec Equipment" <tentec@contesting.com>
Subject: Re: [TenTec] Way off topic request
From: "Stuart Rohre" <rohre@arlut.utexas.edu>
Reply-to: Discussion of Ten-Tec Equipment <tentec@contesting.com>
Date: Tue, 25 Jul 2006 15:41:16 -0500
List-post: <mailto:tentec@contesting.com>
John, the plans for the MFJ 259 are easy to find on the MFJ site, as a line 
drawing of the coil sets.  There are only two coils.  Count the turns in the 
drawing.  You do not need the adapter from RCA to UHF plug.  Simply get some 
plexiglas rod to fit the back end of a PL 259, and wind the coil on that. 
Hold the coil secure with shrink tubing.  I did this for the club MFJ 259, 
and borrowed a MFJ made set and compared them and got same range.

Remember though, that dipping with the MFJ 259 or higher models is done at a 
nominal 50 ohm port, and thus at low impedance you have a low Q circuit and 
shallow dip.

-Stuart
K5KVH 


_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec

<Prev in Thread] Current Thread [Next in Thread>