One other advantage if you are using the N4PY control program is that
1.373b3 dramatically improved the performance of the RF gain control in
Carl's control program. Up to this point you had to set the RF gain from
the rig itself as the RF Gain control in the program did not work properly
in 1.372. Toby W4CAK
----- Original Message -----
From: "Toby Pennington" <toby423@earthlink.net>
To: "Ten Tec List" <tentec@contesting.com>
Sent: Tuesday, August 29, 2006 11:21 PM
Subject: Re: [TenTec] [Orion] Diff between 1.372 and 1.373b5
> 1.371.b1 through 1.373b3 essentially took care of two obvious problems
when
> on cw using version 1.372, but created another problem.
>
> In version 1.372 on cw there were noise bursts which would occur when
> turning the BW encoder and they were deafening if you were using
headphones.
> Also, there were dead spots as you would turn the BW encoder with no
signal.
> Turning the BW encoder past the dead spot would bring the receive back to
> normal.
>
> Esentially, by the time 1.373b3 was sent out these two problems had been
> fixed. But that is when we discovered another newly created problem with
> receiver crashing. Again in cw mode, if you turned the BW encoder and
had
> the sweep running the receiver would crash eventually. The obvious
> workaround was not to run the sweep.
>
> This problem was never solved and exists in 1.373b5 also. Toby W4CAK
>
>
> ----- Original Message -----
> From: "Alan Sewell" <alan.n5na@gmail.com>
> To: <orion@contesting.com>
> Sent: Tuesday, August 29, 2006 10:58 PM
> Subject: Re: [Orion] Diff between 1.372 and 1.373b5
>
>
> > Version 1.373b1
> > - Added additional checks for Curtis keyer control to MENUs. Was only
> > called on power-up.
> > - Add WAIT_FOR_DSP_COMPLETE to mainRF routine. Toby P was reporting
> > noise bursts.
> > - Added call to agc_change in serial AGC routine.
> >
> > Version 1.373b2
> > - Removed call to update xtal filter drivers inside the PBT_BW routine.
> > This is now handled in the interrupt
> > routine. Having it in two placed was causing a conflict when writing to
> > the interface chips.
> > - Added main_dsp_squelch variable to handle MOX for the main receiver.
> > Was inadvertantly using the sub receivers
> > squelch value for the mains MOX unmute value. This caused a SQL problem
> > when the main receiver was in CW mode anytime.
> >
> > Version 1.373b3
> > - Corrected problem in AGC system: Occasional noise burst when BW
> > encoder or the RF gain knob moved.
> >
> > Version 1.373b4
> > - Eliminated passing of AGC info to DSP. This was causing Out Of Band
> > distortion when used.
> >
> > 01/18/05 Version 1.373b5
> > - Modified serial control of SubRx AGC. Was not updating sub receiver as
> > it should.
> >
> >
> > Duane A Calvin wrote:
> > > Does anyone have the errata files for what changed between 1.372 and
> > > 1.373b5? A couple of us here in central Texas are moving back to the
> > > 1.3xx levels until TT gets the 2.x FW fixed for the Orion I's due to
the
> > > superior noise reduction, AGC adjustability, etc., etc. We'll live
with
> > > the sweep/BW interaction problems. But in order to choose between the
> > > two levels mentioned, it would help to know what the fixes were (and
> even
> > > what broke on later 1.373b5 level, if any of that has been
summarized).
> > >
> > > 73, Duane (for me and K5LN)
> > >
> > > --------------------------------------
> > > Duane Calvin, AC5AA
> > > Austin, Texas
> > >
> > > http://www.ac5aa.com
> > > _______________________________________________
> > > Orion mailing list
> > > Orion@contesting.com
> > > http://lists.contesting.com/mailman/listinfo/orion
> > >
> > >
> >
> > _______________________________________________
> > Orion mailing list
> > Orion@contesting.com
> > http://lists.contesting.com/mailman/listinfo/orion
> >
>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|