Hello Mats,
I just did a check on my 509, and I can adjust the RF Output power to
all power levels you mention - by adjusting the Drive control. What
you might need is a power meter that can measure those levels. I use
a homebrew version of W7EL's QRP Directional Wattmeter (Feb 1990 QST),
or there are many others that will do the same job.
Hope this helps.
72/73,
ed - k9ew
On 9/12/06, Mats Strandberg <sm6lrr@gmail.com> wrote:
Hello!
I am the happy owner of a Ten-Tec 509 that according to the manual should be
capable of delivering 3 Watts RF Output.
In the Swedish Portable Contest, there is a Power Multiplier that demands
the RF output to be less than 1 Watt.
Can anyone supply me with information of suitable Power attenuators that
could be used to reduce the 3 Watts down in several steps, for example
1,5W/1W/500mW/100mW?
Thanks in advance for any possible help.
SJ6R - Mats
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|