When you switch between vfo a to vfo b the modes do not follow UNLESS you
have vfo b ALSO set as the sub receiver.
In other words, if vfo b is set as cw, and vfo a is ssb, when you switch A/B
you will not have the mode you want UNLESS vfo b is ALSO set as the sub
receiver. The original mode will be in the new vfo.
I am not accustomed to this. Has any one else seen this?
To me the modes and filter settings should follow the vfo chosen.
Am I not understanding a methodology here?
Thanks.
Mark
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|