There seems to be an issue with some Orion II's with 2.037j that causes the
baud rate to be off a little. The fix is to set the baud rate at 56000 baud
instead of 57600.
Carl Moreschi N4PY
121 Little Bell Drive
Bell Mountain
Hays, NC 28635
----- Original Message -----
From: "David E. Shelton" <des.n4in@gmail.com>
To: <tentec@contesting.com>
Sent: Sunday, October 08, 2006 7:46 PM
Subject: [TenTec] Orion II firmware problems
> Is it just me or does the current version of FW 2.037j have some issues
with
> computer interfacing the Orion II. I can't get DX4WIN, MixW, WriteLog, or
> several others to interface smoothly with 2.037j. I reverted back to 2.034
> and the problems are gone. When will this be fixed? I looks like the FW
was
> released September 7. This is a fairly significant problem that would
affect
> about everyone with these rigs. Is there a work around other than using
> 2.034? Thanks,
> David, N4IN
>
>
>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|