TenTec
[Top] [All Lists]

Re: [TenTec] Vertical radial question

To: tentec@contesting.com
Subject: Re: [TenTec] Vertical radial question
From: Bill Tippett <btippett@alum.mit.edu>
Reply-to: Discussion of Ten-Tec Equipment <tentec@contesting.com>
Date: Wed, 01 Nov 2006 10:16:10 -0500
List-post: <mailto:tentec@contesting.com>
N1VS:
 >I'm putting up a new vertical and faced with a long narrow
lot (50;x30;)

         Cover the maximum area you can.  A simple rule
is given in ON4UN's book which will work even for rectangular
lots like yours.  For the highest band you plan to use,
mark points along the perimeter (rectangule in your case)
that are 0.025 wavelengths apart.  For 160m, this would be
about 13', for 80m 6.5', etc.  Then run a radial from your
vertical to each of these points.  0.025 wavelengths has
been determined empirically to be the effective point to
minimize the number/length of radials, total wire cost and
still have very good effectiveness.  Here is one set of data
which verifies the 0.025wl rule of thumb:

http://www.antennasbyn6lf.com/files/160_m_vertical_measurements.pdf

0.025wl = 24.6/f (f in MHz and result in feet)

                                         73,  Bill  W4ZV




_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec

<Prev in Thread] Current Thread [Next in Thread>