| To: | "Discussion of Ten-Tec Equipment" <tentec@contesting.com> |
|---|---|
| Subject: | Re: [TenTec] Omni VI Question |
| From: | "Carl Moreschi" <n4py@arrl.net> |
| Reply-to: | Carl Moreschi <n4py@arrl.net>,Discussion of Ten-Tec Equipment <tentec@contesting.com> |
| Date: | Sun, 19 Nov 2006 16:22:39 -0500 |
| List-post: | <mailto:tentec@contesting.com> |
It says 10 volts. Carl Moreschi N4PY 121 Little Bell Drive Bell Mountain Hays, NC 28635 ----- Original Message ----- From: "Ed" <w3nr@comcast.net> Cc: "TenTec" <TenTec@contesting.com> Sent: Sunday, November 19, 2006 3:56 PM Subject: [TenTec] Omni VI Question > What is the voltage available at the mic connector ?? > > Ed W3NR > _______________________________________________ > TenTec mailing list > TenTec@contesting.com > http://lists.contesting.com/mailman/listinfo/tentec _______________________________________________ TenTec mailing list TenTec@contesting.com http://lists.contesting.com/mailman/listinfo/tentec |
| <Prev in Thread] | Current Thread | [Next in Thread> |
|---|---|---|
| ||
| Previous by Date: | Re: [TenTec] FW: [QRP-L] Next problem with cw on Corsair, Steve, G4GXL |
|---|---|
| Next by Date: | Re: [TenTec] Omni VI Question, Ed |
| Previous by Thread: | [TenTec] Omni VI Question, Ed |
| Next by Thread: | Re: [TenTec] Omni VI Question, Ed |
| Indexes: | [Date] [Thread] [Top] [All Lists] |