Interesting question. I've wondered about this for a while and had an
opportunity to try my Centaur amplifier with a FT-2000 (in place of my
usual Paragon) in full QSK mode this weekend.
What I did was hook an external keyer to the "key in" jack of the
amplifier and hooked the amplifier "key out" to one of the FT-2000 key
jacks, thus taking advantage of the sequencing in the TT amp. The
FT-2000 key jack was set to operate without the internal keyer. It
seemed to work fine and reports were that the keying sounded the same
either semi or full QSK.
I did have a xmit lock-up but only on 80 m, so most probably a local
grounding issue, not a systematic problem of the connections.
Good to know about the possibilities!
73, Joel
Joel R. Hallas, W1ZR
Ken Kinyon wrote:
If any one is using the Pro III with a Ten-Tec Titan III. I have some questions
about what hook up you use. Particularly with QSK CW.
Thanks,
Ken W7TS
-------------------
Kenneth E. Kinyon
34 Princeton Circle
Longmont, CO 80503-2106
-----------------------
E-mail: W7TS@comcast.net
------------------
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|