Hi Ken,
No, I haven't tried one, but I'm not using any RCA connectors. I'm
still in the stage of getting the mic to work though the RiagBlaster
plus without hum. Could be a ground loop, but it doesn't sound
typically ground-loopy -- the hum is too strong. I'm thoroughly confused...
Kim
At 07:04 PM 11/25/2006, you wrote:
Kim have you possibly tried a line isolator? if that cures the
problem then it is obviously a ground loop somewhere in your
setup. Some inexpensive isolators are available from Radio Shack
http://www.radioshack.com/product/index.jsp?productId=2062214
de ken n9vv
Kim Elmore wrote:
> OK, I'm confused.
>
> I have a RigBlaster Plus that I'm trying to use with my Orion II. I
> have installed the jumpers following the manual diagram, which also
> follows the wiring for Yeasu rigs. I'm experiencing terrible hum on
> the audio and I can't figure out why. What's wrong? How *should* I
> configure the jumpers?
>
> Kim Elmore, N5OP
>
>
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|