Is that when the amp is un-keyed? It could be a problem in the bias board,
or the finals are bad. How does it perform otherwise?
Ron N6IE
www.N6IE.com
(Formerly N6AHA)
----- Original Message -----
From: "KN5H" <kn5h@earthlink.net>
To: <tentec@contesting.com>
Sent: Tuesday, November 28, 2006 11:48 AM
Subject: [TenTec] 425 plate current drawing 100ma when idle and in Hivoltage
only
> Hello to all:
> My 425 amp is acting strangely.
> I noticed when idle, the plate current meter shows approx 100ma.
> Then if I switch the amp's voltage from HI to LOW, it normals out.
> Any ideas?
> Thanks
> 73 de KN5H
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>
>
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|