| To: | tentec@contesting.com |
|---|---|
| Subject: | Re: [TenTec] Circuit breaker tripping excessively A CLUE and a partial fix. |
| From: | OTAKEBI@aol.com |
| Reply-to: | Discussion of Ten-Tec Equipment <tentec@contesting.com> |
| Date: | Thu, 7 Dec 2006 22:24:00 EST |
| List-post: | <mailto:tentec@contesting.com> |
Take off one leg of those diodes and check them to see if they are open or short. Check the ALC section of the board. Don't go adjusting pots. Check for bad components first. You don't want to add to problems. Pots don't change unless you change them. Dan/N4VET |
| <Prev in Thread] | Current Thread | [Next in Thread> |
|---|---|---|
| ||
| Previous by Date: | Re: [TenTec] Circuit breaker tripping excessively A CLUE and a partial fix., Craig Roberts |
|---|---|
| Next by Date: | Re: [TenTec] Noise Reduction Setting, Gary Hoffman |
| Previous by Thread: | [TenTec] FS: TT 302J & 307C, David B Norris |
| Next by Thread: | [TenTec] NEED FILTERS, Jack Wigal |
| Indexes: | [Date] [Thread] [Top] [All Lists] |