Jim: The Spot level is tied to the S-Tone level.
Ron N6IE
www.N6IE.com
(Formerly N6AHA)
----- Original Message -----
From: "Jim Lowman" <jmlowman@sbcglobal.net>
To: <tentec@contesting.com>
Sent: Saturday, December 30, 2006 2:11 PM
Subject: [TenTec] [Fwd: Orion II Spot Control]
>
>
> -------- Original Message --------
> Subject: Orion II Spot Control
> Date: Fri, 29 Dec 2006 22:49:33 -0600
> From: Gary Strong <gjstrong@comcast.net>
> To: <tentec-owner@contesting.com>
>
>
>
> I am new to this list and as of today an owner of an Orion II. I seem to
> be missing something in the manual. Is there any way to adjust the
> “spot” volume when using the control to zero beat a cw signal. Mine is
> very loud and I can’t find in the manual how to lower it.
>
> On a side note, I’ve been running Ten Tec rigs for about 25 years. Just
> moved up from a Corsair II to this Orion. Other than about a thousand
> more buttons, they are a lot alike (well at least they both say Ten Tec)
>
> Thanks!
>
> Gary
>
> KO0Q
>
>
--------------------------------------------------------------------------------
> No virus found in this incoming message.
> Checked by AVG Free Edition.
> Version: 7.1.409 / Virus Database: 268.15.28/604 - Release Date:
> 12/26/2006
>
>
>
--------------------------------------------------------------------------------
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|