Re: [TenTec] Titan III

["David W LeJeune, Sr" <lejeuned@centurytel.net>]

   Just experienced the same thing with my Titan III (line fuses blowing). 
Replaced them, and watched the plate meter pegged twice without the fuses 
blowing.  Happened every time I switched from Standby to Operate.  Each time 
I would quickly switch back to Standby before it blew the fuses.  After a 
few times doing this (switching from Standby to Operate to Standby) it 
settled down to normal operation.  Don't know how long this will last, 
though.  Scarey.  Hardly think it's a problem with the choke arcing - sounds 
like maybe an intermitten grid or screen short?  I'll call TenTec on 
Tuesday.  Titan III is only 6 months old.
Dave K5WNV


----- Original Message ----- 
From: "Charles Delaune" <chas118@cableone.net>
To: "Discussion of Ten-Tec Equipment" <tentec@contesting.com>
Sent: Sunday, December 31, 2006 10:38 AM
Subject: Re: [TenTec] Titan III


> Denny,
>
> My Titan III is just over two months old. Two weeks ago, the line fuses 
> blew
> as soon as I switched from Standby to Operate. I sent it back for repair
> (praying that those clowns at UPS didn't make things worst). It was 
> repaired
> and is on its way back as I type this note. I'm keeping my fingers crossed
> that nothing happens to it during shipping. Because of the horror stories
> I've heard from others, including yourself, about shipping damages, I 
> cringe
> whenever I have to ship equipment via UPS. I wonder if Fed Ex is any 
> better?
> In any case, the problem with my Titan, according to the tech that did the
> repair, was that the plate choke started arching to the chassis when HV 
> was
> applied, which naturally caused the line fuses to blow! Apparently, the
> plate choke is mounted VERY close to the chassis! He applied shrink tubing
> to the tab, on the choke, which was arching, and said that this should
> remedy the problem. He also said that one of the tubes was jarred loose 
> from
> its socket and that I should double check them when I get the amp back, 
> and
> install the transformer. Those UPS idiots must have flipped the box upside
> down and dropped it to cause a tube to jar loose.
>
> I'm supposed to receive the amp and transformer, Tuesday. After what the
> tech at Ten Tec told me about one of the tubes, and reading about the 
> damage
> your transformer received, thanks to UPS, I'm almost afraid to open the
> boxes when they get here!
>
> I'll get a better idea of the "modification" the tech preformed to the 
> plate
> choke when I install the transformer. I seem to recall hearing about a 
> plate
> choke arching problem from another ham I had a QSO with a few months ago,
> but I can't remember if it was with a Centurion or a Titan. In the future,
> if your Titan suddenly starts blowing line fuses, I would first look for 
> any
> signs of arching on the plate choke BEFORE I sent it back to Ten Tec via 
> the
> UPS torture test!
>
> Charlie - N5BLY
> -----Original Message-----
> From: tentec-bounces@contesting.com [mailto:tentec-bounces@contesting.com]
> On Behalf Of Dennis OConnor
> Sent: Saturday, December 30, 2006 8:01 AM
> To: tentec@contesting.com
> Subject: [TenTec]  Titan III
>
> UPS has a way of jarring those things lose.
>
> Charlie - N5BLY
>
>  Yup, good point Charlie... Tubes were OK... What was not was the HV
> transformer... UPS had managed to crush the box, break the plywood 
> shipping
> base, and bend the steel mounting foot on one side...  To do that would
> require that it be dropped, or thrown, from chest high onto concrete...
>
>  I did call TT and talk to the tech who built my amp... He said after he
> aligns the mechanics and electronics,  all final adjustments are made by
> UPS...
>  OTOH, our UPS driver saw the load was from Ten Tec <he recognizes my 
> toys>
> and adjusted his route so he could deliver it to me before I leave the
> office instead of late afternoon...  Hard to complain when you are treated
> that way...
>
>  denny / k8do
>
> __________________________________________________
> Do You Yahoo!?
> Tired of spam?  Yahoo! Mail has the best spam protection around
> http://mail.yahoo.com
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec