TenTec
[Top] [All Lists]

[TenTec] Omni VI Audio level spread.

To: <tentec@contesting.com>
Subject: [TenTec] Omni VI Audio level spread.
From: <k8vf_mark@centurytel.net>
Reply-to: Discussion of Ten-Tec Equipment <tentec@contesting.com>
Date: Sat, 13 Jan 2007 14:29:36 -0500
List-post: <mailto:tentec@contesting.com>
On every Omni VI   I have had, the audio pot is only useable over 10% of its 
range as it is way too loud.

I needed to check out some new filters and had the bottom off of the Omni 
VI,    SO..........


I put a 70 ohm , i/8 watt resistor between wiper and af min on audio pot at 
connector 55 on Lower pot board.

Did this on Lower pot board as it was easiest, you could pull the if/af 
board, too but I did not.

Flip rig with bottom off and front toward you.

Lower pot board is on right front...connect 70 ohms(or so) between 2nd and 
3rd solder trace counting from the left.

Works like a charm. Normal audio level is at 12 o clock now instead of 7 o 
clock........
I didn't have to pull any  boards either.

I can only guarantee this on my rig, not responsible for yours.

Best regards.

Mark
K8VF 

_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec

<Prev in Thread] Current Thread [Next in Thread>