I use Prolog2K for Windows to log DX and general logging.
I notice that the Orion II gives the freq. to the Prolog2K program from VFO
A because when I work split to call the DX and XMIT on VFO B, the program
does not get any freq. information until I switch the TX back to VFO A.
Not a big deal, but it took me a while to figure out what was going on.
Lee Armitage N0LYW
Western Colorado
----- Original Message -----
From: "Duane Calvin" <ac5aa1@gmail.com>
To: "'Discussion of Ten-Tec Equipment'" <tentec@contesting.com>
Sent: Wednesday, January 24, 2007 8:29 PM
Subject: Re: [TenTec] Orion, V2x with WriteLog
None that I'm aware of, Natan. I run WriteLog, DX4WIN (and MMTTY) with my
Orion all the time. It plays very well. Occasionally WriteLog seems to
miss a beat in polling (once every 300+ QSO's in a contest if it's going
to
happen at all) and causes either invalid band to be chosen or the bandmap
window briefly shows an odd freq, then returns with a half second. It's a
very small nit, and easily seen and remedied afterwards.
73, Duane
Duane Calvin, AC5AA
Austin, Texas
www.ac5aa.com
-----Original Message-----
From: tentec-bounces@contesting.com [mailto:tentec-bounces@contesting.com]
On Behalf Of Natan Huffman
Sent: Wednesday, January 24, 2007 8:59 PM
To: tentec@contesting.com
Subject: [TenTec] Orion, V2x with WriteLog
I'm expecting the arrival of an Orion (not Orion II) with version 2.056
firmware and am hoping to use it with Writelog. Are there any known
problems or suggestions when using Writelog and the Orion?
Thank you from a new Ten Tec owner.
Natan W6XR.
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|