Hello Duane. It's very easy and a real experience. Get your radio ready to
transmitt. Then go to www.smeter.com. Pick out a reciever and Call Cq or
something and listen to your signal. The radios are for the most part all out
west. That is what they are for. Art Bell has one of the remote radios. Plus
goobs of other stuff abt Ham Radio on web site. Tell us how it worked out.
Roger W4IV TN.
---------- Original Message ----------------------------------
From: "JAMES HANLON" <knjhanlon@msn.com>
Reply-To: Discussion of Ten-Tec Equipment <tentec@contesting.com>
Date: Wed, 14 Mar 2007 10:09:14 -0600
>Duane,
>
>I am "blessed" with many old, "boatanchor" receivers, and I just use one of
>them with the antenna terminals shorted and the RF gain turned down to listen
>to myself. Perhaps you could find something inexpensive and a bit better than
>the S-38 level at a local hamfest or on the web that would do the trick.
>
>Jim, W8KGI
> ----- Original Message -----
> From: dw<mailto:bw_dw@fastmail.fm>
> To: Discussion of Ten-Tec Equipment<mailto:tentec@contesting.com>
> Sent: Tuesday, March 13, 2007 7:55 PM
> Subject: [TenTec] Whats a good way to monitor your cw signal?
>
>
> My 25 amp power supply did a hick-up last week-end and since then I've
> received
> 2 warble reports on 30.
> No bad reports on other bands though.
>
> I have a small hand-held icom RC-10 which has cw mode, and I listened to
> myself on all bands with it the other day, but I'm not sure if I can
> hear the warble or not.
>
> Running the Jupiter.
>
> On one report, I pulled the power down to 75% and was told it was still
> there.
>
> Your suggestions highly appreciated.
>
> Tnx
> Duane
> N1BBR
> --
> dw
> dw@sover.net<mailto:dw@sover.net>
>
>
>_______________________________________________
>TenTec mailing list
>TenTec@contesting.com
>http://lists.contesting.com/mailman/listinfo/tentec
>
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|