One of my ampkeyer will hand the amp without breaking out a sweat..
here's the url
http://www.theheathkitshop.com/_ampkeyer.html
and if the key line is positive and you are really looking for cheap,
then check this one out too
http://www.theheathkitshop.com/universalkeyingi.html
this guy can go inside the amp, will key positive lines up to 250V at
6 amps using a power mosfet and is optically coupled to the rig
mike
Mike, WB8VGE
SunLight Energy Systems
The Heathkit Shop
http://www.theheathkitshop.com/
J e e p
o|||||||o
Note: No trees were killed in the sending of this message, but a
large number of electrons were terribly inconvenienced
On Apr 6, 2007, at 3:28 PM, Dr. Gerald N. Johnson wrote:
On Fri, 2007-04-06 at 13:30 -0500, JD & KK McCrary wrote:
> Is anyone using these in combo? Advice on keying the Heath with an
> Orion.
>
>
>
> Thanks,
>
> Dalton - W4WUQ
>
You will probably need a relay or MOSFET interface to key the Heathkit
amplifier unless it has (unlike earlier Heathkit amplifier) a 12 volt
under 200 ma key input.
--
73, Jerry, K0CQ,
All content copyright Dr. Gerald N. Johnson, electrical engineer
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|