Hi,
Has anybody experienced absolutely huge noise
which is being produced when N4PY upgrade chip
is installed ?
I am not asking about the noise whose existence
cannot be denied, but a possible cure which
perhaps can be administered to remove it ?
As far as I can see the noise is being produced
mainly by frequency/mode polling sequences.
The moment the comport is closed the noise is
substantially reduced.
When I checked and re-installed the original chip
paragon was brought to its previous hush state of
operation, so I am pretty sure where the glitch
has been located.
Yours,
Alec/SP2EWQ
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|