On the Unofficial Ten Tec site in the "links" area is the mod for a Omni V
to bring it down to QRP levels. I'm using the ALC off and using the drive to
lower power but it drifts a bit up. Not a major problem but wondering if a
similar mod of some sort could be done ?????
OMNI V QRP Mod
--------------------------------------------------------------------------------
Mod: Provides a means lowering the power output to QRP levels.
Procedure:
Paul Clinton, Ten-Tec's Service Manager, advises to replace R46 on the 9 MHz
Filter Board from 100K-ohm to10K-ohm @ 1/4 watt. This brings the Omni V's
minimum output level to QRP.
73s
George , N2JNZ
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|