Grant:
I noticed the same thing, almost immediately. Not a biggie at this end.
John K4NP
----- Original Message -----
From: "Grant Youngman" <nq5t@tx.rr.com>
To: "'Discussion of Ten-Tec Equipment'" <tentec@contesting.com>;
<orion565@yahoogroups.com>
Sent: Saturday, May 12, 2007 12:12 PM
Subject: [TenTec] 2.060b S-Meter "0"
> I've discovered today that the s-meter "zero" position on my orion with
> 2.060b installed is about S-1.5. With 1.3xx software installed it sites
> dead on S-1 where it is supposed to.
>
> Can anyone with a v2 Orion and 2.060b confirm where the S-meter sits with
> no
> signal no antenna?
>
> Thanks ... Grant/NQ5T
>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|