I presume the loop is enabled? Are you sure your amp is pulling the
handshake line (TX EN) "low"? When your amp is powered off, is this line
held "low" by default? Does the radio key if you put a shorting plug in TX
EN?
Just trying to suggest some proof tests.
Grant/NQ5T
> -----Original Message-----
> From: tentec-bounces@contesting.com
> [mailto:tentec-bounces@contesting.com] On Behalf Of Jerry.Van
> Sent: Thursday, May 17, 2007 1:13 PM
> To: tentec@contesting.com
> Subject: [TenTec] Orion I and keying loop w. 2.061f
>
> Just loaded 2.061f on my Orion I and noticed that the keying
> loop does
> not work. Even with my amp off the Orion does not key up on CW (have
> not tried it on phone). Turning the keying loop off does result in
> being able to transmit. No hardware changes of any kind were
> made with
> 2.061f. Anyone else have this problem?
>
> Jerry N8BM
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|