The sidetone on 2.039d sounds pretty decent. I can hear a bit of an echo
sounds and something that sounds a bit like scissors snipping when I have
the phones set to list to both the Main and Sub receivers and CW Rise/Fall
is > 4. It gets stronger as you got to 10 ms. Not really all that
bothersome.
I don't hear any distortion on sound peaks on the O2.
Ron N6IE
www.N6IE.com
----- Original Message -----
From: "Merle Bone" <merlebone@charter.net>
To: <tentec@contesting.com>
Sent: Sunday, May 20, 2007 8:54 PM
Subject: [TenTec] V2.061f Issues
>I ran V2.062f for about a day and then went back to V1.373b5. A lot of
>progress has been made with issues in the V2 firmware. However, although
>the "big pop" is no longer at the end of each code element on the CW
>sidetone, there is a "raspy sound" that sounds like an "AGC tail." I slowed
>the CW down to 3WPM and you can clearly hear the "rasp" at the end of each
>code element (At higher speeds it just sounds "noisy."). I wonder if this
>is also on the Orion II sidetone or if it is unique to the Orion?
>
> Also, on receive, I hear a very grating distortion on "sound peaks,"
> particularly on noise peaks. The higher the system gain, the worse the
> distortion gets. So if you turn off the preamp, the distortion is
> reduced - but not eliminated. The combination of the distortion on receive
> and the "raspy sound" at the end of each code element on the sidetone just
> "wore me out" after a number of hours of operation.
>
> Hoping for a "simple" resolution to these two issues.
> 73, Merle - W0EWM
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>
>
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|