Hi Rick...you stateside yet? Gotta cure fer the drifties...my old Omni 6
plus did a bit of that so pulled the speaker and installed a little pc fan
to pull in cool outside air that is wired in series with one across the
final brick heat sink.
Having a lot of fun setting up my Omni 7! Now if only could get the darn
ethernet port to work....
----- Original Message -----
From: "Rick, NJ0IP / DJ0IP" <Rick@DJ0IP.de>
To: "'Discussion of Ten-Tec Equipment'" <tentec@contesting.com>
Sent: Tuesday, May 22, 2007 5:40 PM
Subject: [TenTec] Omni VI+ drifting frequency
>I have an Omni VI+ opt. 3 which was shipped to me via UPS.
>
> The rattle inside the rig turned out to be the plastic cap of the TCO,
> which
> apparently came lose in shipping.
>
> I pushed it back on.
>
> I did not glue it.
>
>
>
> When using the rig, it drifts significantly, to the extent that I need to
> adjust the VFO about once per minute.
>
> It seems to be drifting, not jumping.
>
>
>
> Any suggestions?
>
> Do I need to glue the cover to the TCO on to the unit?
>
>
>
> Thanks.
>
>
>
> 73
>
> Rick
>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|