TenTec
[Top] [All Lists]

Re: [TenTec] Mod for Paraagon to 60 meters and other questions

To: tentec@contesting.com
Subject: Re: [TenTec] Mod for Paraagon to 60 meters and other questions
From: W4UOC@aol.com
Reply-to: Discussion of Ten-Tec Equipment <tentec@contesting.com>
Date: Thu, 28 Jun 2007 16:42:46 EDT
List-post: <mailto:tentec@contesting.com>
 
In a message dated 6/19/2007 10:32:44 P.M. Eastern Standard Time,  
n8coo@yahoo.com writes:

Tom,

1. The Paragon can be modified to transmit 1.7-30 MHz by  cutting the
"Ham" jumper on the Logic Board.  See page 6-79 of your  manual. Of
course you have to properly adjust the frequency, mode, and  power for
the 60 meter "channels".

2. I haven't had any problem with  the clock freezing so can't help
there.

3. I have isolation  transformers and a 5k pot on the input (transmit
audio) so I can adjust the  drive. I use the rear jacks for sound card
inputs/outputs and works  well.  That way I can leave the microphone
plugged in. With the  Ten-Tec 705 mic I'm using the mic audio is
isolated  when the PTT  button isn't pressed, so I don't have to worry
about room noise getting in  the signal. (I have the switch on the
bottom of the 705 set to PTT).   I also have a switch on the interface
to cut the transmit audio I can use  so computer noises don't get in the
rig unintentionally when I'm not using  sound card modes.




Mark....
 
Thanks for all your suggestions.
 
As it turned out the HAM Jumper had already been cut and it works fine on  60 
meters.
The other problem I had was the display was so bright I could see all the  
digits I wanted to see....plus I could see all the digits that should have been 
 
blank.  It turned out that there is a jumper to have either high or low  
brilliance.  I changed the jumper to low and the screen looks fine and now  the 
clock works too.  Go figure.
I probably just got a better connection on the connection to the clock  
display... But it's been fun cleaning up these few glitches.
 
I don't know why but I really like this Paragon.  I have a lot of  rigs but 
for some reason this is becoming my favorite.  I like the fact it  is so 
versatile.  I like the general coverage receiver features and the 6  khz filter 
for 
AM.  I only wish I had the Paragon II so it would work AM,  which is my 
favorite mode. As you can see on my web page.  
 
_www.members.aol.com/w4uoc_ (http://www.members.aol.com/w4uoc) 
 
Tom Koch - W4UOC



************************************** See what's free at http://www.aol.com.
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec

<Prev in Thread] Current Thread [Next in Thread>