TenTec
[Top] [All Lists]

Re: [TenTec] OMNI-6+ cw offset adjustment

To: Discussion of Ten-Tec Equipment <tentec@contesting.com>
Subject: Re: [TenTec] OMNI-6+ cw offset adjustment
From: Clark Savage Turner <csturner@kcbx.net>
Reply-to: Discussion of Ten-Tec Equipment <tentec@contesting.com>
Date: Sun, 1 Jul 2007 09:19:49 -0700
List-post: <mailto:tentec@contesting.com>
On Jul 1, 2007, at 8:18 AM, Bob Henderson wrote:

> CW offset is indeed adjustable from the front panel and I believe 
> sidetone
> pitch tracks CW offset.  What is not adjustable is filter centering, 
> which
> is fixed at 800Hz.  If you're happy listening to a tone between 
> 600-1000Hz
> this works fine with cascaded filters as narrow as 500Hz.  However, if 
> your
> preferred receive tone is 450Hz this doesn't work nearly so well.  The
> problem is significantly exagerated if 250Hz filters are used.  Years 
> ago, a
> bunch of folks had filters made with lower centre frequency, so as to 
> deal
> with this problem.  I'm not sure but I suspect Inrad made the filters 
> and I
> believe they were centred somewhere around 600Hz.

Bob has this right.  You can go ahead and set the CW tone offset and if 
you want to use a narrow CW filter in the NAR position (the 9 MHz IF) 
you are stuck in the passband (fixed) of the 9 MHz CW filter.  If you 
like to hear CW at the lower notes (below 500 Hz, like I do), you'll 
suffer loss at the edge of the filter response.  Of course, you can use 
your PBT control to work with the 6.3 MHz CW filters, no problem there, 
but the NAR filters in the 9 MHz position have fixed center frequency 
and you can't move that (well you can realign the radio...)

Yes, Ten Tec asked Network Sciences to make them a filter to deal with 
this, I was probably the original guy to ask for, and to receive, a 
model 221 CW filter.  This is the 250 Hz CW filter for the 9 MHz IF 
with a 500 Hz center frequency, beats heck out of the model 219 for 
listening at the lower tones, allows me to hear "down into the noise" 
quite well.  The  model 219 filter is 250 Hz wide with the 750 Hz 
center frequency, if you try to listen down at 500 Hz you suffer awful 
loss (and with my 221, if you wanted to listen up at 750 Hz you'd 
suffer the same sort of loss).

Clark
WA3JPG

Clark Savage Turner, J.D., Ph.D.
Professor of Computer Science
Cal Poly State University
San Luis Obispo, CA. 93407

_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec

<Prev in Thread] Current Thread [Next in Thread>