No, the transverter output on the back of the Orion and Orion II is a very
low level milliwatt output. It is not sufficient to drive the 1209. Also,
my software and the N3FJP logging program work very well togther.
Carl Moreschi N4PY
121 Little Bell Drive
Bell Mountain
Hays, NC 28635
----- Original Message -----
From: "Doug Turnbull" <turnbull@net1.ie>
To: <tentec@contesting.com>
Sent: Wednesday, July 04, 2007 12:34 PM
Subject: Re: [TenTec] Six Meter Transverter
> Carl,
> Thank you very much for the reply! Two hundred watts is better than
I
> hoped for. Once I get another computer I will take another look at your
> software along with my logging software from N3FJP which I use after a
> contest to renter all my contacts into. This is a crazy approach as I
well
> know. Thank you again for your information. One question though can I
> just use the low power output from the back of the Orion 2 for the
> transverter rather than needing to adjust the power level manually. It
> would be easy to forget to correctly set the power and then watch the
> transverter smoke. I understand that your software would automate the
> power level for me. Thanks again and Happy Fourth to all in W land.
>
> 73 Doug EI2CN
>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|