Re: [TenTec] Orion - What's this trim pot?

[Dave Heil <k8mn@earthlink.net>]

Ron,

Thanks very much for the information.

73,

Dave K8MN

Ron Castro wrote:
> I think you are describing R340, the meter calibration pot.  You'll find it 
> in the schematics for the original Orion in the A7 group, 81917_10.pdf.
>          Ron Castro
>  Chief Technical Officer
>     Results Radio, LLC
>                N6IE
>       www.N6IE.com
>
>
> ----- Original Message ----- 
> From: "Dave Heil" <k8mn@earthlink.net>
> To: "Discussion of Ten-Tec Equipment" <tentec@contesting.com>
> Sent: Friday, August 17, 2007 10:17 PM
> Subject: [TenTec] Orion - What's this trim pot?
>
>
> > I'm finally getting around to doing the sweep mod on my Orion.  I
> > removed the covers this evening.  I know about the master transmit audio
> > gain pot and the contrast post under the lip of the front panel.
> >
> > Can someone tell me the function of the pot which is behind the top edge
> > of the front panel and visible after removing the top cover?  There is
> > an access hole for it on the black, ventilated metal strip just behind
> > the panel.
> >
> > 73,
> >
> > Dave Heil K8MN
> > _______________________________________________
> > TenTec mailing list
> > TenTec@contesting.com
> > http://lists.contesting.com/mailman/listinfo/tentec
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec