TenTec
[Top] [All Lists]

Re: [TenTec] Omni VI and non TT Amp

To: tentec@contesting.com
Subject: Re: [TenTec] Omni VI and non TT Amp
From: "Dr. Gerald N. Johnson" <geraldj@storm.weather.net>
Reply-to: geraldj@storm.weather.net,Discussion of Ten-Tec Equipment <tentec@contesting.com>
Date: Wed, 07 Nov 2007 23:36:43 -0600
List-post: <mailto:tentec@contesting.com>
On Wed, 2007-11-07 at 23:28 -0600, Bob McGraw - K4TAX wrote:
> Do keep in mind that replacing 811's with 572's will only allow the amp to 
> perform to the limit of the power supply as designed for 811's.  In practice 
> there is no advantage unless one desires to stress the power supply beyond 
> its design rating.
> 
> Yes, running the 572's at the lower voltage will greatly extend their life. 
> As to pushing the current higher on the 572's than the 811's to get more 
> output, one only has to wonder how long the power supply will last.
> 
> 73
> Bob, K4TAX
> 
And the output tank components. Besides which the coil taps are set to
give a certain plate load R and to get more power from drawing more
plate current with 872B the plate load R needs to be smaller. Yes, you
can reduce the loading C but as you do you also change the loaded Q and
the harmonic rejection of the output tank.

73, Jerry, K0CQ

_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec

<Prev in Thread] Current Thread [Next in Thread>