[Top] [All Lists]

Re: [TenTec] A dumb question....

To: <w6fg@pacbell.net>,"Discussion of Ten-Tec Equipment" <tentec@contesting.com>
Subject: Re: [TenTec] A dumb question....
From: "Arthur Trampler" <atrampler@att.net>
Reply-to: Arthur Trampler <atrampler@att.net>,Discussion of Ten-Tec Equipment <tentec@contesting.com>
Date: Thu, 6 Dec 2007 12:36:42 -0600
List-post: <mailto:tentec@contesting.com>
I haven't played with this (I don't even know if the Omni VI does CW-R but 
don't think so) but my quick solution would be an "A=B" on the VFO switch 
and then set the second VFO for CW...the one thing I'd have to think about 
would be any necessary change in frequency, and once I knew in my mind if 
that was necessary I'd use the XIT to set it on the transmit (CW) VFO.

Slightly O-T from this...has anyone modified the the "A=B" circuitry so that 
it has to be depressed, perhaps for a couple of seconds, before working to 
prevent accidentally making such a change?


----- Original Message ----- 
From: "Ross F. Guldenbrein" <w6fg@pacbell.net>
To: <tentec@contesting.com>
Sent: Thursday, December 06, 2007 12:32 PM
Subject: [TenTec] A dumb question....

> Hi gang,
>  Well I'm really going to expose my ignorance here... but I'm sure some of 
> you with 'multi-mode experience will know the answer.  I'm running an Omni 
> VI (opt 3).  I don't have a mic here but let's say I'm listening to SSB 
> and I want to send a CW signal on that frequency... How do I do that? 
> When I key in USB or LSB I don't hear any side tone.  If I change the mode 
> to CW I can't make out the voice sig.  Is there a simple way to do this?? 
> Thanks for replies.
>  Ross
>  W6FG
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec 

TenTec mailing list

<Prev in Thread] Current Thread [Next in Thread>