For RTTY it is rated 1000 watts output for 10 minutes of transmit time with
a 50% duty cycle. i.e. 10 minutes transmit, followed by 10 minutes of
receive. Follow the TUNE UP procedure in the manual and do not over drive
the amp. Pay very close attention to Screen current and grid current. Be
sure the load/antenna is near 50 ohms i.e. SWR <1.5:1 before starting to
tune the amp. Start with 10 watts of drive from the exciter.
While it is well protected, overdrive can make for expensive and sudden
tube replacement needs.
And, if you don't have a manual, order one from Tentec.
73
Bob, K4TAX
----- Original Message -----
From: <W1dxh@aol.com>
To: <tentec@contesting.com>
Sent: Thursday, January 17, 2008 4:12 PM
Subject: [TenTec] 425 titan
> hello to all,
> i am a newbie to rtty and was wondering if anyone has
> used the 425 titan on rtty? at what power did you run it at, and is there
> any
> thing i should know before hand. thanks any info appreciated. don't want
> to
> smoke anything hi hi.
>
> 73's,
> steve w1dxh
>
>
>
> **************Start the year off right. Easy ways to stay in shape.
> http://body.aol.com/fitness/winter-exercise?NCID=aolcmp00300000002489
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|