TenTec
[Top] [All Lists]

Re: [TenTec] 425 titan

To: tentec@contesting.com
Subject: Re: [TenTec] 425 titan
From: Mike Gorniak <mgorniak@genesiswireless.us>
Reply-to: mgorniak@genesiswireless.us,Discussion of Ten-Tec Equipment <tentec@contesting.com>
Date: Fri, 18 Jan 2008 11:22:43 -0600
List-post: <mailto:tentec@contesting.com>
Steve,

I'll second that! As far as I know, there is no protection for Grid 
Overdrive on the 425. There is an "Overdrive" LED that indicates that 
too much power is being applied to the amplifier. The 3CX800A7 grids 
have limited power dissipation capability, and they are expensive to 
replace. My advice is to make a tuning chart that includes the 
transceiver (or transmitter) Output Power as part of the reference. That 
way, you don't have to push the grids too hard before knowing where "too 
hard" is each time you tune up.

73,

Mike
NM7X

Original Message

------------------------------

Date: Thu, 17 Jan 2008 18:04:22 -1000
From: Ken Brown <ken.d.brown@hawaiiantel.net>
Subject: Re: [TenTec] 425 titan

Hi Bob,

The Titan 425 uses a pair of 3CX800A7 triodes. Your advice to watch the 
(control) grid current is good. There is no screen grid.

DE N6KB


-- 
This message has been scanned for viruses and
dangerous content by MailScanner, and is
believed to be clean.

_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec

<Prev in Thread] Current Thread [Next in Thread>