TenTec
[Top] [All Lists]

Re: [TenTec] jpreamp and rf gain

To: <geraldj@storm.weather.net>,"Discussion of Ten-Tec Equipment" <tentec@contesting.com>
Subject: Re: [TenTec] jpreamp and rf gain
From: "John" <brazos@rochester.rr.com>
Reply-to: Discussion of Ten-Tec Equipment <tentec@contesting.com>
Date: Mon, 21 Jan 2008 20:08:29 -0500
List-post: <mailto:tentec@contesting.com>
Thanks for your reply Jerry .  John kb2huk
----- Original Message ----- 
From: "Dr. Gerald N. Johnson" <geraldj@storm.weather.net>
To: <tentec@contesting.com>
Sent: Monday, January 21, 2008 12:12 PM
Subject: Re: [TenTec] jpreamp and rf gain


> On Sun, 2008-01-20 at 18:11 -0500, John wrote:
>> Hello all !  I have a question .  I was just listening to the TT net on 
>> 14.329 and some one made reference to listening to his Orion II with the 
>> RFgain way down and then putting on the radio's preamp .  Does this 
>> procedure cancel each other out or what am I missing here ?  I thought 
>> the preamp increases the noise along with the signal ?  Thanks for 
>> setting me straight .  John kb2huk
>
> Partly. Could be the preamp has lower internal noise than the standard
> RF stage. And less gain, so for the noise and nearby QRM conditions the
> combination heard weak signals better and wasn't as often overloaded by
> close by (frequency or location) strong signals. Mixers are nearly
> always the weak link and minimizing the RF gain before the mixer can
> often be a great benefit in rejecting strong unwanted signals (which
> could include power line noise), but having no gain in front of a mixer
> (which is inherently noisier than an amplifier stage) can set a signal
> detection threshold higher than the strength of the desired signal.
>
> Could also be that there is an RF gain setting that works without the
> preamp just as well as the preamp on with lowered RF gain, but sometimes
> "RF" gain also controls IF stage gains too and lowered RF gain sets up a
> threshold condition where the noise is reduced while the not quite
> really weak signal is copied just fine making for a better S/N ratio at
> the speaker. There are many ways to run a receiver, and that's why it
> has knobs and buttons to allow the user to optimize it for his own needs
> and the conditions at the time.
>
> 73, Jerry, K0CQ
>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec 

_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec

<Prev in Thread] Current Thread [Next in Thread>