TenTec
[Top] [All Lists]

[TenTec] Orion firmware gripes!

To: Ten-Tec Reflector <tentec@contesting.com>
Subject: [TenTec] Orion firmware gripes!
From: Rick Williams <ve7asr@yahoo.com>
Reply-to: Discussion of Ten-Tec Equipment <tentec@contesting.com>
Date: Mon, 25 Feb 2008 11:12:20 -0800 (PST)
List-post: <tentec@contesting.com">mailto:tentec@contesting.com>
Well I guess it's time to gripe again.  I have an
Orion 565 and I'm running Version 1.373b5 firmware.  I
personally feel that, with respect to the firmware,
we've been cast adrift by Ten-Tec.  The recent
discussion of the well know AM sub-receiver issue
brings this to light.

Don't get me wrong, I love my Orion BUT it has some
issues and many are well known.  Here's my list -- in
no particular order:

1) The sub-receiver AM problem
2) Need to improve the Version 2.xxx noise reduction
algorithm (I have the luxury of being able to go back
to Version 1.3xx firmware - O II owners do not).
3) Fix the auto/manual notch.  (In Version 2.xxx if
your listening to an S-3 signal and an S-9 carrier is
notched out the meter says .... surprise the signal
you're listening to with the notch gone is S-9.)  I
was told by T-T that moving the notch in firmware
slightly improved the specs.  I'd be curious if the
slight improvement was noticeable by a user or just by
a lab instrument!
4) IF the way to operate Version 2.xxx is, as
described on this reflector recently, with the audio
gain wide open and manipulating the RF Gain then
Ten-Tec fix that!  Without a dedicated knob for RF
Gain control this is a pain and can be hard on the
ears.

Ron, N6IE, ( http://www.n6ie.com/Wish%20List.htm ) has
a more extensive list but it's obvious that the Orion
still needs some attention.  P-L-E-A-S-E!

Ten-Tec I know resources are scarce but the Omni VII
firmware seems to be improving - have you given up on
the Orion? 

Finally - before anyone asks, NO I'm not about to sell
my Orion and move on.  Here's why.  I recently was
asked to help a friend sell a old top of the line
non-T-T rig that was last produced in 1999. 
Apparently this rig is not wanted without an updated
eprom.  For the last 2 years the manufacturer has not
supported the rig and will not be producing any
updated eproms.  So here's a rig, less than 10 years
old, that cost in the vicinity of $3,000 and it's a
door stop.  Ten-Tec has helped many of us over the
years with older rigs.  Some parts are not available
BUT it seems in their service department a 10 year old
rig is barely broken-in!  I sincerely thank them for
this and that's what keeps me here!

Now I'm off to find my "flame-proof" suit.

73,
Rick
VE7TK


      
____________________________________________________________________________________
Looking for last minute shopping deals?  
Find them fast with Yahoo! Search.  
http://tools.search.yahoo.com/newsearch/category.php?category=shopping
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec

<Prev in Thread] Current Thread [Next in Thread>