Re: [TenTec] TenTec Digest, Vol 63, Issue 2

["Bill Axelrod" <bill@axelrods.org>]

All,

    Thank you all for the kind advice.  And especially, thank you Carl N4PY 
for the fix.  My new Orion II is now fully back in operation!
Thanks again and 73...   Bill
----- Original Message ----- 
From: <tentec-request@contesting.com>
To: <tentec@contesting.com>
Sent: Sunday, March 02, 2008 9:09 PM
Subject: TenTec Digest, Vol 63, Issue 2


--------------------------------------------

> Message: 9
> Date: Sun, 2 Mar 2008 15:43:50 -0500
> From: "Carl Moreschi" <n4py@arrl.net>
> Subject: Re: [TenTec] Orion II won't transmit or receive
> To: "Discussion of Ten-Tec Equipment" <tentec@contesting.com>
> Message-ID: <067501c87ca6$2409da60$6401a8c0@wilkes.net>
> Content-Type: text/plain; charset="iso-8859-1"
>
> Do a battery reset by powering off and holding the VFOB LCK button and
> powering on until it says "battery failure".
>
> Then do a normal reset by holding the "Main RX/TX" button the same way.
>
> Then do a power off and on one more time.
>
> This clears everything.
>
> 73,
>
> Carl Moreschi N4PY
> 121 Little Bell Drive
> Bell Mountain
> Hays, NC 28635
> ----- Original Message ----- 
> From: "Bill Axelrod" <bill@axelrods.org>
> To: <orion565@yahoogroups.com>; <tentec@contesting.com>;
> <service@tentec.com>
> Sent: Sunday, March 02, 2008 11:08 AM
> Subject: [TenTec] Orion II won't transmit or receive
>
>
> > Help please.
> >
> >      I have a brand new (one month old) Orion II which was working fine
> until this morning.  When I came down and turned the rig on it looked 
> fine.
> But I can not hear any signals on any band with the main receiver.  And 
> when
> I try to transmit I get no power out at all.
> >      The transceiver keys, I hear the side tone, but it does not deliver
> any power.  Same when I hit the tune button.
> >      Same problem with either vfo.  And same problem with antenna 1 or 2.
> The sub receiver seems to work OK.  The transmitter is NOT disabled in the
> TX menu.
> >      Any thoughts on what I should look for or at?  Is there a button or
> switch I may have inadvertently thrown?
> >      I have disconnected all the ancillary equipment and have a dummy 
> > load
> connected directly to the antenna 1 connector.
> > Thanks and 73...   Bill K3WA
> > _______________________________________________