Woody:
Happy Easter!
Does the problem happen on all bands? If only on one band, check the
bandswitch and look for cold solder joints on the coils on the Bandpass
Filter board, 80976 (not to be confused with the PBT board, 80979).
Look at the block diagram to see th elements that are common to receive
and transmit, like the Low Pass filter, T/R switching and the Bandpass
Filter.
73,
Bob WB2VUF
Woody Hester wrote:
> My Corsair II often will not load more than 5-10 W & the receive signal is
> weak. When I gently slap the rig on the right side it comes up to full power
> and the receive signal comes to normal. I'm going to open it up this weekend
> to look for loose connections, cold solder joints etc. I'm a hobbyist
> (business major) so any advice re: what to look at first appreciated. The
> rig was brought up to factory specs / aligned by TT about 4 mos. ago, was
> given a clean bill of health and performed flawlessly until this developed
> recently. Happy Easter to all! Woody / WD9F
>
> ---------------------------------
> Never miss a thing. Make Yahoo your homepage.
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>
>
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|