John wrote:
Hello I was on the air today with my Orion II and I was getting some
interference from a nearby station I tighten up the band pass filter and
started playing with the PBT and hi - lo cut . I realized that I still don't
understand the operation of these controls to move the offending stations or
move away from this station. I fiddled with these controls and was unable to
remove the offending station the controls seemed to do very little if anything
. Is there a good explanation of how to use these controls some where . One
question , do I have to have the pbt light on before I attempt to use the H or
L cut feature ? Thanks John kb2huk
Hello John,
Take a look at http://www.tentecwiki.org/doku.php?id=566
Scott W4PA, wrote an excellent article on the Hi-Low cut settings.
'73 Mark, PA5MW
pa5mw.blogspot.com
|