| To: | Discussion of Ten-Tec Equipment <tentec@contesting.com> |
|---|---|
| Subject: | Re: [TenTec] Ten-Tec 9 MHz filters |
| From: | d.e.warnick@comcast.net |
| Reply-to: | Discussion of Ten-Tec Equipment <tentec@contesting.com> |
| Date: | Thu, 22 May 2008 00:19:02 +0000 |
| List-post: | <mailto:tentec@contesting.com> |
According to my old TenTec literature, (Pt. No. 74089), Z-in and Z-out are each 200 ohms, the same as the 6 MHz filters. This 9 MHz document shows the same info for the 216, 217, 218 & 219 filters Dave WA3MKB -------------- Original message -------------- From: Rick Williams <ve7asr@yahoo.com> > Would anyone on the reflector know the input impedance > of the Ten-Tec 9 MHz filters? > > Thanks, > > 73, Rick > VE7TK > > > > _______________________________________________ > TenTec mailing list > TenTec@contesting.com > http://lists.contesting.com/mailman/listinfo/tentec |
| <Prev in Thread] | Current Thread | [Next in Thread> |
|---|---|---|
| ||
| Previous by Date: | Re: [TenTec] FS: 302R remote encoder/keypad, Barry N1EU |
|---|---|
| Next by Date: | Re: [TenTec] Low Pass Filter, Jim WA9YSD |
| Previous by Thread: | [TenTec] Ten-Tec 9 MHz filters, Rick Williams |
| Next by Thread: | [TenTec] A bit off topic...antenna question, Mike Bryce |
| Indexes: | [Date] [Thread] [Top] [All Lists] |