Remember a number of comments on this subject. Mine stopped working...
sometimes it will bounce between 0 and -10 but that is about all. I can
set up the remote POD for RIT XIT and it works great from there....
pressing the front panel RIT control causes the proper clear. The RIT
XIT buttons come on as they should. Running 2.062a. Reloaded firmware
numerous times. Did RAM and Hardware RESETS numerous times as well.
For those who have experienced this.... what were your resolutions?
73,
Jerry, KG6TT
--
KG6TT
Ralph Jerald "Jerry" Volpe
ARRL Member, VE, East Bay Division
FISTS Member 12304
Solano County
CM88xg
788 Chestnut Drive
Fairfield, CA 94533
USA
kg6tt@arrl.net
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|