i am not sure about the O II, but i set the O to the following for CW:
XTAL filter 1 KHz, cuts the noise greatly
BW 1500 or less for same reason
RF gain at about 80
AF gain at whatever sounds good to my ear
AGC to program (default settings)
jack ak7o
----- Original Message -----
From: <Kc9cdt@aol.com>
To: <tentec@contesting.com>
Sent: Sunday, September 28, 2008 6:11 PM
Subject: Re: [TenTec] Orion II settings (John)
> John,
> There has been numerous posts here on starting points and guidlines on how
> to
> setup an OII...did you happen to use any of those? Do you mostly do SSB or
> CW?
>
> If not that would be a good starting point....by the way I rarely use high
> and low cut. Just BW and passband settings mostly. And I really don't play
> with
> the AGC much now that I have it the way I like...I do adjust the threshold
> sometimes.
>
> 73,
> Lee, KC9CDT
>
>
> **************
> Looking for simple solutions to your real-life
> financial challenges? Check out WalletPop for the latest news and
> information,
> tips and calculators.
> (http://www.walletpop.com/?NCID=emlcntuswall00000001)
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|