Do you have the speech processor turned ON? If so turn it off.
----- Original Message -----
From: <DieselCar@aol.com>
To: <tentec@contesting.com>
Sent: Saturday, December 27, 2008 12:11 PM
Subject: Re: [TenTec] TenTec Digest, Vol 72, Issue 28
> Hi Ed,
>
> When running PSK31 on my Orion II, I run high tones. That is, around 2000
> Hz. Therefore, the PBT is set about 1950 and TX EQ is set to -20dB.
>
> This setup also is used when using AFSK on RTTY. However, I use FSK 99.99%
> of the time on said mode.
>
> GL and Happy New Year.
>
> Rick W4UEF
>
> <
> Hello all:
>
> I am trying to get my Orion II running 2.039D to run PSK 31 using Digipan
> and WinPsk. I seem to be having a bit of difficulty with the Orion
> settings. I am using a Buxcom Rascal box with a straight thru Din cable
> and
> I can receive and decode fine on the laptop. I can transmit on the
> Orion,
> and can hear it on an external receiver transmitting PSK 31 but there
> does
> not appear to be much if any drive to the transmitter. The transmit
> light
> on the Orion does not light and the meter does not move. My external
> tuner
> (LDG Z 11 Pro) also does not light either as it does in SSB mode.
>
> I have the Orion using the aux mode as the input with the gain up to 60.
> The CW selection is set to MOX and the TX EQ is 0.00 db.
>
> Any suggestions as to drive settings on the Orion II would be most
> appreciated ?
>
> 73s
>
> Ed W3ETC
>>
>
>
> **************One site keeps you connected to all your email: AOL Mail,
> Gmail, and Yahoo Mail. Try it now.
> (http://www.aol.com/?optin=new-dp&icid=aolcom40vanity&ncid=emlcntaolcom00000025)
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|