To: | tentec@contesting.com |
---|---|
Subject: | Re: [TenTec] Corsair II / 263 VFO Question |
From: | "Dr. Gerald N. Johnson" <geraldj@storm.weather.net> |
Reply-to: | geraldj@storm.weather.net, Discussion of Ten-Tec Equipment <tentec@contesting.com> |
Date: | Sun, 08 Mar 2009 09:33:52 -0600 |
List-post: | <tentec@contesting.com">mailto:tentec@contesting.com> |
On Sun, 2009-03-08 at 11:09 -0400, W8KZW wrote: > I have a Corsair II that works fine with my remote 263 VFO in line. > > When I remove the vfo and jumper the VFO IN and OUT jacks together on the > rig, it fails to work and returns a 91.0000 in the display. > > Shouldn't jumpering return the radio to an internal vfo only mode? > > Any thoughts would be appreciated. > > Thanks, & 73, > Jeff > W8KZW > Needs a jumper on the Accessory socket. Pin 2 to 6 according my my Corsair II manual. Lower left corner of the block diagram page. 73, Jerry, K0CQ _______________________________________________ TenTec mailing list TenTec@contesting.com http://lists.contesting.com/mailman/listinfo/tentec |
<Prev in Thread] | Current Thread | [Next in Thread> |
---|---|---|
|
Previous by Date: | Re: [TenTec] Corsair II / 263 VFO Question, Dr. Gerald N. Johnson |
---|---|
Next by Date: | Re: [TenTec] Corsair II / 263 VFO Question, Steve Hunt |
Previous by Thread: | Re: [TenTec] Corsair II / 263 VFO Question, Dr. Gerald N. Johnson |
Next by Thread: | Re: [TenTec] Corsair II / 263 VFO Question, Steve Hunt |
Indexes: | [Date] [Thread] [Top] [All Lists] |