Most of these problems are in the COM port of your computer. Are you using
an RS-232 serial port on the computer or serial-to-USB adaptor? In any
case, check your Device Manager, make sure you have the right COM port
selected, and set it to 57,600 8-N-1. Re-boot everything and start over.
Ron N6IE
www.N6IE.com
----- Original Message -----
From: "dbp tds.net" <dbp@tds.net>
To: "Tentec reflector" <tentec@contesting.com>
Sent: Sunday, April 05, 2009 10:13 AM
Subject: [TenTec] ORION II latest version 2.04 failure to load
Hi-
Not having any success loading the new version 2.04XL for the ORION II. It
will get to load to line 10 of 5012 and halt at that point.
Currently I'm running version 2.039 and DSP2.016b14 so I think the loader
program is up to date.
I have been off line so would have missed updates since early March.
Any suggestions?
Dave
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|