Date: Mon, 27 Apr 2009 16:26:09 -0400
From: Martin Ewing <martin.s.ewing@gmail.com>
Subject: Re: [TenTec] How do I select BC frequencies?
To: Discussion of Ten-Tec Equipment <tentec@contesting.com>
> Not quite right! You have to use the sub-receiver, which is general
> coverage. The sub-receiver can be controlled by either VFO A or B.
> But you have to be sure the main receiver is not also on the same VFO,
> because that limits you to ham bands only.
Actually, you CAN set the main rcvr AND the xmtr both to frequencies well
outside of the ham bands -- you do it by using rig control software. I don't
think it has continuous coverage, and I have no idea how far from spec the xmtr
will be if taken very far outside of the ham bands, but it certainly can be
done. Ten-Tec's little secret. ;)
! Adam Wade -==- AF6ME -==- Ten-Tec Orion & SteppIR BiggIR Mk III !
! "I write down everything I want to remember. That way, instead !
! of spending a lot of time trying to remember what it is I wrote !
! down, I spend z time looking for the paper I wrote it down on." !
! - Beryl Pfizer -=- http://www.allthings550.com !
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|