seems the radio works, but not with someone else's software, so that means
it's a problem with
Ten-Tec's software????
Call N4PY seems more appropriate
--------------------------------------------------
From: "Rick W" <ve7tk@yahoo.ca>
Sent: Friday, May 15, 2009 1:27 AM
To: "Ten-Tec Reflector" <tentec@contesting.com>
Subject: [TenTec] Orion 565 Problem with 2.063Xg??
> I think I've found a problem with 2.063Xg. Here's the scenario.
>
> 1) I have my 565 under the control of the N4PY software.
> 2) I go to the RX menu and toggle the AGC System Type (it doesn't seem
> to matter which way I go).
> 3) Back out of the menus
>
> After doing this exercise I lose all serial control of the Orion. In
> addition the remote pod doesn't work. The work-around is to turn off the
> software and reboot the Orion.
>
> IF I am not using the serial port with an external program and toggle the
> AGC the remote pod works BUT when I try to start some external software
> the serial port is dead. The same work-around solves the problem.
>
> Before I report this to T-T I'd be curious if others are experiencing
> this?
>
> Thanks.
>
>
> 73,
>
> Rick
>
> VE7TK
>
>
>
> Website: http://www3.telus.net/ve7tk
>
>
> __________________________________________________________________
> The new Internet Explorer® 8 - Faster, safer, easier. Optimized for
> Yahoo! Get it Now for Free! at
> http://downloads.yahoo.com/ca/internetexplorer/
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|