The mic gain in the Orion N4PY program is remembered by band. You can set
the mic gain for each band one at a time in the N4PY SSB settings window and
the program will remember these values when returning to each band.
Carl Moreschi N4PY
121 Little Bell Drive
Bell Mountain
Hays, NC 28635
www.n4py.com
----- Original Message -----
From: "Denton" <denton@oregontrail.net>
To: "Discussion of Ten-Tec Equipment" <tentec@contesting.com>
Sent: Thursday, July 02, 2009 2:02 PM
Subject: [TenTec] ten tec orion 1 N4PY software mic gain audio level drop
>I have a new to me Orion 1 running version 2.063Xg and I notice that when I
> run N4PY's Orion control software that the mic gain audio input drops way
> down compared to running the Orion after a master reset.
> Tried setting the sliders in both the Orion and N4PY menus and have a
> little
> luck that way.
> Anyone notice the same? Workaround?
> I have to run for 15 thru 10 meters the mic gain at about 100 percent with
> 10-13 db of hardware gain...which I think is a bit much....
> I have to drop the mic gain way down from 14 on 80 meters and increase it
> to
> 31 on 20 meters.
>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|