On Wed, 2009-09-02 at 18:14 +0000, Mahaini, Saad A wrote:
> Hello, I'm looking for the schematic if possible or at least the pinout
> of the power connector . 73 Saad N5FF
>
>
The standard connections like on a Corsair II are:
Pin 1 (bottom of rig) is ground.
Pins 2 and 3 are the switch on the radio volume control. Won't handle
more than a couple amps. Its intended to switch the power supply 120
volt line input.
Pin 4 +12 to 14 volts.
The book says Pin 1 has a rib on the plastic part of the cable connector
and pin 4 has a rib on the chassis connector.
73, Jerry, K0CQ
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|