To: | "'Discussion of Ten-Tec Equipment'" <tentec@contesting.com> |
---|---|
Subject: | [TenTec] Argonaut 509 |
From: | "Gary Harmon" <gharmon@idworld.net> |
Reply-to: | Discussion of Ten-Tec Equipment <tentec@contesting.com> |
Date: | Fri, 13 Nov 2009 20:22:06 -0600 |
List-post: | <tentec@contesting.com">mailto:tentec@contesting.com> |
I bought a pickup load of old HAM stuff this week and in the pile was a sad looking 509. Besides the cabinet and sides unfastened, there were two little switches added to the front panel and one to the back. One of the front switches was marked CW FILTER and the one on the back was marked AGC. Were these common mods or just someone's attempt to improve the radio? Are these little radios still in demand? 73, Gary H. Harmon, Jr. - K5JWK 6003 Archwood San Antonio, TX 78239-1504 210.657.1549h 210.884.6926c _______________________________________________ TenTec mailing list TenTec@contesting.com http://lists.contesting.com/mailman/listinfo/tentec |
<Prev in Thread] | Current Thread | [Next in Thread> |
---|---|---|
|
Previous by Date: | [TenTec] WTB Hercules II, Andrew Moore |
---|---|
Next by Date: | Re: [TenTec] Hercules II drive requirement, d . e . warnick |
Previous by Thread: | [TenTec] WTB Hercules II, Andrew Moore |
Next by Thread: | Re: [TenTec] Argonaut 509, Karl Schwab |
Indexes: | [Date] [Thread] [Top] [All Lists] |