TenTec
[Top] [All Lists]

Re: [TenTec] "FIX IT" list for Orion II v. 2.041XL

To: "Discussion of Ten-Tec Equipment" <tentec@contesting.com>, <TenTec_Orion@yahoogroups.com>
Subject: Re: [TenTec] "FIX IT" list for Orion II v. 2.041XL
From: "N4PY2" <n4py2@earthlink.net>
Reply-to: N4PY2 <n4py2@earthlink.net>, Discussion of Ten-Tec Equipment <tentec@contesting.com>
Date: Tue, 24 Nov 2009 10:06:42 -0500
List-post: <mailto:tentec@contesting.com>
By the way, my N4PY software is now fully compatible with N1MM contest software.

Carl Moreschi N4PY
121 Little Bell Drive
Hays, NC 28635
www.n4py.com


----- Original Message ----- From: "Harry van Enckevort" <Harry.van.Enckevort@tiscali.nl>
To: <tentec@contesting.com>; <TenTec_Orion@yahoogroups.com>
Sent: Tuesday, November 24, 2009 9:50 AM
Subject: [TenTec] "FIX IT" list for Orion II v. 2.041XL


Hello,

Thought maybe it is of "interest" fer all on the list now to let U know
what I wrote to Stan Brock in july  (bcuz of ordering a tuner kit)

Quote
"By the way i like the "recent" 3041XT (beta) firmware release fer the
Orion (in particular the additional waterfall) but maybe a hint:  bring
the top line of the spectrum/waterfall on the same level as the Send 1
line (L) and the bottom of the RF gain (R). This to give the filter/BW
icons the height again they "deserve" hi hi.

By the way maybe a hint fer ur programmer(s) :

In contesting I still miss the ability to have the menu item in other
menu "Remote Pod Enc" available on the POD F buttons....(N4PY software
may do this but is not compatible with N1MM contest logger  ao) and are
50Hz tuning steps impossible bcuz of the design ?
Just some suggestions."
Unquote

This is what he replied:

Quote
"I will pass along your thoughts to the engineering team."
Unquote

Just fer ur info and what it is worth.
73 es cu in the contest
Harry
PA3ARM@arrl.net





_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec


<Prev in Thread] Current Thread [Next in Thread>