Connect "TX Out" to the amp's "Key In". Then connect the amp's "Key Out" to
"TX EN". This should work great for both CW and SSB. That's exactly what I
do with my Acom 1000.
Carl Moreschi N4PY
121 Little Bell Drive
Hays, NC 28635
www.n4py.com
----- Original Message -----
From: "Brickey, Dennis" <dbrickey@eastman.com>
To: <tentec@contesting.com>
Sent: Friday, December 04, 2009 5:45 AM
Subject: [TenTec] Tentec XCVR Keying Loop and Amp Supply Amp Question?
> Hi Group,
>
> I recently acquired an Amp Supply LK-500NTC with vacuum relay QSK. The
> amp has a pair of RCA jacks for "Key In" and "Key Out." Does anyone know
> if it is possible to use the "TX EN" and "TX Out" keying loop in late
> model Tentec xcvrs to key this amp? The amp manual says to connect a
> keyer to the "Key In" jack on the amp and connect the "Key Out" on the amp
> to the CW key jack on the radio such that the amp controls the radio. It
> would sure be nice if the Tentec keying loop could be used instead.
>
> Thanks for any and all advice.
>
> Dennis N4DD
>
>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|